Leading wire forming machine manufacturer specializing in the development of welding technology.
Wire mesh weld strength testing should establish whether a joint meets its intended duty under an agreed test method. A neat surface alone cannot demonstrate mechanical performance. Identify how the panel is loaded in service, whether the weld holds spacing or transfers a functional load, and which customer specification applies. Set the acceptance criteria before running a trial rather than choosing a limit after viewing the results.
A cross-wire joint can respond differently to separation, shear and bending. Select a method with the customer and a qualified quality engineer. Define specimen preparation, gripping arrangement, loading direction, test rate and result units. A manual twist or peel check may reveal process changes, but it should not replace a specified quantitative test. Use suitable guarded test equipment and trained personnel for destructive testing.
Record both wire directions, including grade, actual diameter, coating and lot. A change in surface condition can alter the welding process even when the nominal diameter is unchanged. Identify contamination, rust or coating variation before the trial. Retain representative incoming material so a later investigation can distinguish material variation from a machine adjustment. Never combine results from different materials without identifying them clearly.
Create a panel map with identifiable weld positions. Include locations that represent the actual process, such as edges, central intersections and different electrode positions. Include samples from the agreed stages of a run rather than selecting only the best initial panel. Determine sample quantity and frequency from the customer specification and process risk. There is no universal sample count that establishes suitability for every wire mesh application.
Visual checks should record missing welds, excessive indentation, expulsion, deformation and surface damage. Mechanical tests answer a different question. A panel can look acceptable while containing weak joints; it can also show an appearance problem despite meeting a particular strength threshold. Maintain separate fields for appearance, dimensional condition and mechanical acceptance so one favorable result does not erase another failure.
Identify whether failure occurs through the joint, in the wire near the weld or elsewhere in the specimen. Record fixture slip, unintended bending and any invalid test. Photograph the failed specimen and retain its panel coordinate. Failure in the parent wire is useful information, but it does not by itself establish compliance with every application requirement. Interpret the force and failure mode together under the agreed method.
After a parameter or tooling change, keep material, specimen preparation and test conditions comparable. Record the previous and revised settings and the reason for the change. Electrode condition should also be documented: the related electrode wear and welding quality article provides context for investigating a drift in weld consistency. Do not adjust several variables simultaneously unless the trial plan specifically requires a combined change.
The automatic multi-spot welding machine is a relevant product starting point for discussing mesh welding. Confirm its configuration against panel size, wire arrangement and access requirements. Send Jinchun Machine the drawing, material details, target output and agreed test method. Request traceable trial samples, a panel sampling map and a signed result record. Release production only after unresolved failures have an agreed disposition.