loading

Leading wire forming machine manufacturer specializing in the development of welding technology.

How to Troubleshoot Slug Pulling in Wire Punching

×
How to Troubleshoot Slug Pulling in Wire Punching

Identify the scrap movement

Slug pulling occurs when cut-out scrap returns upward with the punch instead of leaving through the intended path. Scrap blockage occurs when discharged material accumulates or becomes trapped. They may coexist, but the observations needed to distinguish them are different.

Repeated dents in flattened wire may indicate loose scrap entering another cycle. A dent alone does not prove slug pulling: damaged tooling, debris and handling can leave similar marks. Preserve defective samples and their production order before cleaning removes the evidence.

Inspect the complete discharge route

Stop and isolate the machine under its approved procedure before accessing tooling or clearing scrap. Observe operation through guards or an approved camera arrangement. Never reach into the die space to follow a slug.

Inspect punch, die opening, stripping or retention features and the full scrap channel. Include containers that can fill during a longer run. Record tool identification, wear and accumulation location. A clear die opening does not prove that the downstream path stays clear.

Compare the workpiece and tool condition

Check flattened thickness, width, hole location, burr and surface marks against the drawing. Keep the recovered scrap with the corresponding workpiece where practical. A change in wire or flattening condition can alter punching behavior even with unchanged settings.

Have a tooling engineer evaluate punch and die condition, clearance, penetration, stripping and scrap retention. Lubrication may affect adhesion, but changing it blindly can introduce new problems. Do not apply a universal clearance or pressure value without the actual material, section and tooling design.

Change one controlled factor at a time and save the baseline. If tooling is replaced, record the new identification. Do not enlarge a hole or polish away a mark merely to conceal a symptom; the feature must still meet its drawing.

Verify continuous operation and restart

Run an agreed trial that includes consecutive output and a controlled stop and restart. Follow scrap behavior as the collection system fills. Inspect samples in sequence for recurring marks, hole condition and dimensions. One clean stroke is insufficient evidence of stable scrap handling.

Record material lot, tool IDs, settings changed, trial part count or duration, stop events and the disposition of suspect output. Acceptance should confirm that the symptom remains controlled and that other features have not deteriorated.

Send Jinchun Machine the drawing, material, flattened section and defective samples. Ask how the proposed machine supports scrap discharge, inspection and cleaning. A useful equipment trial reproduces the failure mode and documents the correction rather than showing only selected good parts.

Related technical guidance and equipment

Use the related diagnosis guide to compare this symptom with other punching defects. See wire flattening and punching defects guide.

Review the corresponding integrated equipment and confirm the proposed scrap-handling design. See automatic flattening punching and straightening machine.

FAQ

1
Does every dent indicate a pulled slug?
No. Compare scrap shape, tooling condition, debris and handling evidence.
2
Will more lubricant solve it?
Not necessarily. Lubrication is one process variable and must suit the tooling.
3
Why include restart?
A stop can expose changed scrap positions or accumulation not seen in a short run.
prev
How to Check Compression Spring Load at Two Heights
recommended for you
Get in touch with us

Foshan Jinchun is a technology-intensive industrial company specializing in the development of welding technology and equipment research and manufacturing, integrating scientific research, production and sales.

Contact Us
Address: No.25 Sanle Road, Beijiao Town, Shunde district, Foshan City, Guangdong Province, People's Republic of China 
Contact:  Charles
We chat:  18038626853
Copyright © 2026 Foshan Jinchun Industrial Automation Technology Co., Ltd. All Rights Reserved  www.jinchunmachine.com | XLC  | Sitemap  |  Privacy Policy
Contact us
phone
email
wechat
whatsapp
Contact customer service
Contact us
phone
email
wechat
whatsapp
cancel
Customer service