loading

Leading wire forming machine manufacturer specializing in the development of welding technology.

How to Check Compression Spring Load at Two Heights

×
How to Check Compression Spring Load at Two Heights

Read the loaded heights correctly

A spring can meet a free-length target and still deliver the wrong force in service. Testing at two specified heights checks two working conditions and permits an interval rate calculation. It does not replace every other requirement on the spring drawing.

Loaded height is the remaining overall spring height under compression. Deflection is the reduction from free length. Confusing them creates an incorrect test even when the instrument is precise. Record both required heights, force limits and any conditioning, loading-direction or dwell requirements.

Prepare a repeatable test

Identify the sample, material lot and finished processing condition. Confirm whether acceptance follows stress relief, grinding, coating or another operation. Free length is useful context but cannot replace force measurement.

Use a calibrated force and displacement system with suitable capacity and resolution. Check platen alignment, height reference and support method. Inconsistent seating or tipping can change the readings. Use approved guarding and handling; keep hands clear of compression surfaces. Conditioning cycles should follow the specified method rather than an improvised number.

Measure and calculate the interval rate

Approach both heights in the same prescribed direction and at the agreed rate. Record the actual force at each height, including dwell where specified. Do not compress beyond the approved limit simply to obtain another point. Repeat selected measurements to identify seating or zero errors before changing production settings.

Let H1 be the higher loaded height and H2 the lower height, with forces F1 and F2. Interval rate k = (F2 − F1) / (H1 − H2). Force in newtons and height in millimeters give N/mm.

Illustrative calculation only: 40 N at 30 mm and 70 N at 20 mm give k = (70 − 40) / (30 − 20) = 3 N/mm. These are teaching values, not Jinchun test results or acceptance limits. This interval rate does not prove linear behavior beyond the two points.

Accept forces as well as rate

Compare each force with its own specified limit. A spring can have the expected interval rate while both forces are shifted from target. Do not average away individual failures when the specification requires individual compliance.

Record sample ID, drawing revision, free length, test heights, forces, treatment condition and instrument identification. Compare paired samples through finishing if investigating a change. When measurement differences are large, resolve the test method before assuming the coiling process is unstable.

Send the complete force requirements with the spring drawing and wire specification to Jinchun Machine. Ask for a demonstration in the final inspection condition. A machine motion or feed specification does not guarantee finished spring load or fatigue life.

Related technical guidance and equipment

Review related geometry and processing variables when force results change. See spring diameter and pitch variation.

Use this corresponding coiling product as the basis for a sample trial. See CNC compression spring machine.

FAQ

1
Does this establish fatigue life?
No. Fatigue requires a separate defined evaluation.
2
Is rate the same as load?
No. Rate describes force change per unit deflection over a defined interval.
3
Can different loading directions be mixed?
Only when the approved method permits it; otherwise keep the direction consistent.
prev
How to Check Nesting Clearance in Stackable Wire Baskets
How to Troubleshoot Slug Pulling in Wire Punching
next
recommended for you
Get in touch with us

Foshan Jinchun is a technology-intensive industrial company specializing in the development of welding technology and equipment research and manufacturing, integrating scientific research, production and sales.

Contact Us
Address: No.25 Sanle Road, Beijiao Town, Shunde district, Foshan City, Guangdong Province, People's Republic of China 
Contact:  Charles
We chat:  18038626853
Copyright © 2026 Foshan Jinchun Industrial Automation Technology Co., Ltd. All Rights Reserved  www.jinchunmachine.com | XLC  | Sitemap  |  Privacy Policy
Contact us
phone
email
wechat
whatsapp
Contact customer service
Contact us
phone
email
wechat
whatsapp
cancel
Customer service